English to Greek Other Other TECHNICAL

EXCEL SHEET

Select the product model you want to setup.

Select Model

Keep a minimum space of 1 reflective bar length on vertical direction, and 1 or 2 reflective bar lengths on horizontal direction depending on the projection size.

Keep a minimum space of 12cm (1 digitizer height & 3cm) above the projection area.

Connect the USB cable from the digitizer with the USB extension cable.

Attach the wall mount bracket on the back of the digitizer plates using 2 machine screws.

Attach the digitizer so that it is parallel to the projection area and the triangle mark points to its centre.

Keep a space of 3cm between the projection area and the digitizer.

Secure the digitizer using the supplied wood screws.

Attach the reflective bars to the bottom side of the installation surface in accordance with the width of the projection area.

Adjust the size of the projection area if the width of the reflective bars is insufficient.

Secure the ｒeflective bar using the supplied wood screws.

Make sure the silver surfaces of the reflective bars being connected by their corners.

Attach the reflective bars so that the higher part can cover 12cm (1 digitizer height & 3cm) of space above the top edge of the projection area.

Attach the reflective bars on the side so that the lower part can completely cover the projection area.

Attach the corner piece to the lower left and lower right corners of the reflective bar.

Secure the cable holder using the supplied wood screws.

"Connected device is not StarBoard Link EZ.
Please check the model of the device."